Example:    

      4” Pipe = 0.00 movement

      6” Pipe = 0.17

      8” Pipe = 0.33

     10” Pipe = 0.50

     12” Pipe = 0.67

Patent Pending

To use:

· You can direct read the depth of the invert when the pin is set at “zero offset” on the Pipe Mic.

· If you need clearance under rod to measure an invert move the pin to “1’ vertical offset hole”

· If you need clearance under rod and a pipe that is hard to reach you can add a 1 ft.

        extension. (1 ft. extension sold separately) Move pin to “1’ vertical offset w/1’ extension” hole.

To size a pipe:

The foot is 0.33 or 4”.  Take the reading from the rim, pull up and take reading plus 0.33 and that is your pipe size.

PIPE MIC

 

Part #                     List Price

1702PM2                 $185.00

 

1712EXT2               $65.00

 

4 lb.

By pulling a pin in just seconds you can go from zero to 1 ft. vertical offset for clearance under rod.

Measurements are more accurate

because you are measuring with a

vertically plumb rod.

· Made for Crain 25’ SVR and USL rods.

· Made of lightweight (two pounds) non rusting aircraft aluminum.

· No tools needed to attach to rod.

· Slides on and off rod in seconds.

· 24” measuring arm can be extended to 36” by adding 1ft extension.

New round foot design slices through material at bottom of pipe and insures accurate invert and  pipe diameter measurement.

(Pronounced “ PIPE MIKE”)

New Double Sided PIPE-MIC II® Rod

· Made Exclusively for the PIPE-MIC II®

· Reduces multiple set ups when using a Total Station or Auto Level

· Same Great Rod now printed in tenths on front & back of rod.

PIPE-MIC II® Double Sided Rod 25’ 10ths

Part # 172510

List Price $246.00